Interface

Explore the basic layout and learn how to use Liquify.

Layout

The Liquify panel and UI appear after selecting a curve and tapping 'Liquify' in the bottom menu.

Liquify Panel (Side)

1. Liquify Type

Shows the current liquify type. Tap or drag to change the liquify type.

2. Size

Shows the current size of the liquify area. Slide up or down to adjust the liquify size.

3. Range

Shows the current range of the liquify effect. Slide up or down to adjust the range.

4. Strength

Shows the current strength of the liquify effect. Slide up or down to adjust the strength.

Bottom Context Menu (Bottom Center)

5. Switch to Transform

Tap to immediately switch to Transform.

6. Undo All

Reverts to the state before liquify was applied.

7. Compare

Allows comparison between the pre-liquify and post-liquify states.

8. Apply

Applies the liquify.

Liquify Panel

Adjust the liquify type, size, range, and strength.

Change Liquify Type

Use different liquify types depending on the situation.

Tap the liquify icon at the top of the Liquify panel to change the liquify type. Alternatively, tap and hold the liquify icon and drag up or down to quickly switch between liquify types. Each liquify type has unique characteristics. Try them out to see the differences.

Tap and Slide to Adjust Size

Tap the second icon in the Liquify panel and slide up or down to adjust the size of the liquify area. The liquify area size remains consistent regardless of zoom level.

Tap and Slide to Adjust Range

Tap the third icon in the Liquify panel and slide up or down to adjust the range of the liquify effect. Adjusting the range modifies the size of the inner circle. Inside the inner circle, the liquify effect is fully applied, while it gradually decreases toward the outer edge.

Tap and Slide to Adjust Strength

Tap the fourth icon in the Liquify panel and slide up or down to adjust the strength of the liquify effect. A higher liquify strength results in greater influence on the modified curves.